#5) To exit from this command-line access the end command is used. RouterX (config-line)# line vty 0 6 (6 denotes that 6 virtual telnet options are available) #4) For denoting the virtual terminal for remote access, the following command is used – line console vty line number. #3) The login command is used to verify if the password is enabled or not to login into the Router. #2) The next step is to assign a password for access. This command denotes the type of the line and console terminal used for accessing the Router. #1) The first command is line console| tty | vty ] line number. The commands under this category are used to provide only limited access of Routers to the users or we can say that the access of routers is managed by a remote user or administrator. RouterX (config)# -–> Returns to the simple configuration mode. Router(config)# the configuration has been saved and by using the exit command we step out from the loopback interface. #4) The understanding will become better with the help of the following. Login: Router1 (specify login id, here login id is Router1) #3) By using telnet, we can login into the router with the username and password from the remote end system.

#2) For performing configuration on the router from the remote end using the console port we need to enable the configure terminal mode. #1) Now we need to configure the router with some basic parameters like enabling hostname, password and enabling the terminal for configuration. In the above default configuration details, we can see that all the interfaces are down and there are no IP addresses and not any route are allocated to any port or interface of the router. Here, I have given an example of a few of the important lines shown by the router, when we enter the show running-config command into the router with the help of two screenshots. The show running-config command is used to see the starting configuration of the router. Whenever we boot our Router first, there is always some default configuration that exists into it. Home Router Configuration Vs Company Set-up Routers.Configuration of Gigabit Ethernet Interfaces.

What is router configuration page